Monday, July 9, 2012

Introduction


Even communities have memories. 

We all have stories -- sometimes they're stories about ourselves, our families and friends, about where we live and work and play. But most of those stories -- even the good ones -- are lost forever. 

Here's what we can do: we can tell each other the stories we want to keep, recording them -- preserving them for each other and for the future. Then we put them in a database, an archive that can be searched using keywords, and ideally something you can use on the Internet, from anywhere. 

This is what we call Community Memory, and it's what we are building right now as part of the Community Communication Project. Yes, you could say it's a local version of the national StoryCorps project, but it's also a little bit more. 

Join us [join@communify.org] and meet together as we figure out how to make our Community Memory into something unforgettable. 




The first initial meeting for this Action is Monday, July 16, 2012 at 6 pm (MACC on Signal Mountain, Room 5). 

1 comment:

  1. Adhering to some primary rules of injection molded half design will end in a part that, in addition to being easier to fabricate and assemble, will usually be a lot stronger in service. Dividing a part into primary teams will allow you to to construct your Warm Winter Mist Humidifiers half in a logical manner whereas minimizing molding issues. As a part is developed, all the time bear in mind how the half is molded and what place to} do} to minimize stress. Our thermoplastic injection molding is a regular process involving an aluminum mould with no heating or cooling lines working via it, which means cycle times are a bit longer. As {part of|a half of} the scientific molding process, our molders independently optimize and monitor fill velocity, hold stress, and hold time, and periodically inspect half high quality and cosmetics.

    ReplyDelete